Oct 5, 2017

Brand new demo video of the Wampler Paisley Drive Deluxe by Mike Hermans, here’s some info about this baby directly from the manufacturer’s website:

There’s been a lot of demand for Wampler’s long-since-discontinued Underdog overdrive pedal. And a lot of that demand comes from Brad Paisley. So to improve upon his already great-sounding Paisley Drive, Wampler provides you access to the Underdog’s Nobels-like grit right alongside Brad’s signature tone. Channel 1 replicates the distinctive Underdog overdrive that continues to inspire Brad Channel 2 is the same versatile, amp-like drive of the Paisley Drive Each channel can be run independently or stacked in any order you choose.

To integrate with today’s super-powerful pedal switchers and MIDI-based rigs, Wampler outfitted the Paisley Deluxe with the ability to route your signal to each channel individually. With a simple stomp of your programmed switcher, you’re able to pull up either channel or a blend of both. It truly is like having two Brad Paisley-approved overdrive pedals in one box.

  • Independent in and out jacks for each channel
  • Channels are individually selectable via pedal switchers
  • Can be run as two independent pedals or stacked either way

Choosing “stacked” vs. “separate” channel switching

The toggle switch has 3 settings: 2>1, Separate, and 1>2.

Looking at the top of the pedal, the input jacks are on the right side (with an arrow pointing towards the knobs) and the output jacks are on the left side (with an arrow pointing away from the knobs). C1 means “channel 1” and C2 means “channel 2” on the jacks.

When in 2>1 mode and both channels are “on”, the guitar is routed into channel 2, then channel 1. The input cable from the guitar needs to be moved to the “C2” input jack, and the output cable to the amp needs to be moved to “C1” output jack. When in 1>2 mode and both channels are “on”, the guitar is routed into channel 1, then channel 2. The input cable from the guitar needs to be moved to the “C1” input jack and the output cable to the amp needs to be moved to the “C2” output jack. When the toggle is in the middle it is in “separate” mode, and the pedal can be used as two individual pedals, both with its respective input and output jack. – More info here.

 

Related Posts